2002 Mitsubishi Montero "intake manifold" Questions

...intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more ...

Were is the Intake Air Temperature of Montero 3.0 year 1995 ? Follow the intake pipe from the air filter to the intake manifold.Should find it then

...) 53-55 ft lbs. exhust manifold 11-16 ft lbs. intake manifold 11-15 ft lbs. main bearing cap 55-61 ft lbs. rocker shaft 14-15 ft lbs. valve cover 27-35 in. lbs. throttle body bolt 84-108 in.

...intake manifold. Remove the timing belt. Disconnect the exhaust pipe from the manifold. Remove the water outlet pipe and o-rings. Remove the water passage assembly. Remove the water pipe assembly. ...

...intake manifold. So, one, what would have caused this, and two, whats the best way to get to it to fix it, am i really going to have to take off the intake manifold?? The sooner the better or the ...

...Intake Manifold? From what I have been reading online... The upper and middle manifold MUST be removed to get to the spark plugs to change them. 3 hour job minimum. should cost between $300 and $500. ...

...intake manifold. Their will be a coulpling bolted in the manifold. Pull off and replace with factory thermo. follow the Upper coolant hose on the radiator to the engine block. it should have a couple ...

...is entering the combustion chamber either thru the head gasket or intake manifold gasket. Unless the cylinder head is damaged internally, these are the two prime areas that will cause this

...to know which side is intake and which side is exhaust. the side nearest the exaust manifold is the exaust lifters for inlet nearest to carb hope this makes sence even on v8 ect  the same ...

...manifold has to come off to get at them Expensive exercise if taken to mechanic due to the cost of the parts and time to do it Good luck I have done it. If you are good with engines, it should take ...