2002 Mitsubishi Lancer "torque settings" Questions

Torque Settings I have a 1.3 Mitsubishi Lancer 2001 and I need torque settings for the exhaust manifold ( attached to the engine block ) and the connection point to the downpipe. Can anybody help ? 30

torque settings for 2005 lancer es fly wheel gearbox etc 2.0L Evolution engine flywheel bolts 132 =/- 5 N.m. 98 +/- 3 ft lbs. transmission to engine bolts 48 +/- 6 N.m. 36 +/- 4 ft lbs. 2.0L Non- ...

...front wheel with a chaulk block or a brick. I would loosen your lug nuts just to break the intial torque I would then jack up the rear of your vehicle and set jack stands under your car in the ...

...torque settings for headbolts I have a 1994 1.5 litre Mitsubishi Lancer with a 12 valve engine. Located to the right of the rocker cover is the distributor and coil assembly. I have to replace the ...

...on the motorway, any idea what the garage may have done wrong ,i know they did not use a torque wrench when they did the nut up ,could they have either over tighten it or left it slack

...other trick? I'm not sure about this car, but was the belt tensioner replaced and properly set (torque/orientation)? Many have a spring and if its not put in properly it may be fine when turned

...torque settings)when fitting it to the engine. ) 1. Are there any cracks in the cylinder head. This must be tested, 2. Are there any cracks in the engine block. This must be checked. Less likely than ...

...torque+settings Torque setting for Ford Courier F8 motor from main bearing Fixya https://www.fixya.com > Forum > Cars & Trucks > Ford 10 hours ago - Main Bearings Torque specs. 40-43 Ft. Lbs. ...

...Torque settings Big End Torque and Main Bearing Torque settings please? Question edited for clarity. In the link ...

Torque Settings on a 1994 BMW 318i? when a new engine is put in the car,then ypu have to set the torque settings where in this case i do not know how to set the torque settings The torque settings is ...