...clutch plate of the compressor. use a wrench to turn the nut at the center of the clutch. see if the plate turns either way. it should..if it does not turn, then it is frozen. tnx 4 using fixya, ...
Question about Mitsubishi Galant
...compressor/clutch frozen up so belt slips and smokes. If it's the clutch can that be replaced without disturbing the compressor? If it's a bearing I guess it is in the compressor and would require ...
...compressor pulley/clutch so you can run the defrost on the climate control. many GM cars will run the a/c when you switch the climate control to defrost especially in the winter so the a/c system ...
Question about Cars & Trucks
...clutch engages, and the frozen compressor loads the engine through the serpentine belt so much that it kills the engine. Did the serpentine belt squeal or make any noises before the present situation ...
...clutch off the compressor (maybe, if it isn't frozen to the shaft). FYI, I just replaced my AC compressor and found that a new compressor with a new clutch was only about $40 more than the clutch ...
clutch broke on a/c compressor and installed a used one. took it to get charged but still wont work. they said the compressor wouldnt turn. or it may be a fuse but i dont know where the fuse for it is
..... if A/C belt drives other accessories also you will need to reroute others..if compressor not frozen you and clutch not damaged where it is not wobbling or changed its position (run out) you may b ...
...the compressor clutch was not turning and then it will turned and stop again and when I tried to drive it in manual gear it didn't work. What does this mean? The compressor is most likely frozen
Question about Oldsmobile Cars & Trucks
belt I need? Laurie, why bypass the compressor? - even if it is frozen, as long as the AC clutch is not activated there will not be an issue. To be safe just disconnect the wire powering the AC clutch
Question about Mitsubishi Galant
...compressor/clutch. If clutch can it be replaced without disturbing the compressor? Assume there's a bearing in the compressor that could also cause the problem in which case is the compressor shot? I ...
1,147 questions posted
Usually answered in minutes!
851 Questions
799 Questions
704 Questions
325 Questions
312 Questions