2001 Mitsubishi Eclipse Spyder "map" Questions

2001 Eclipes, engine keeps shuts down when coming to a stop, starts back up, when down shifting will also shut down. Idle for a little while and then shuts down .run okay otherwise check map sensor

...and are getting a code 25 Barometric (BARO) pressure sensor fault. Sounds like your car needs a MAP/MDP Sensor. You can usually pick one up from your local parts

...fuse panel under the dash or in the trunk of some cars). Open the fuse panel, and you should see a map of the fuses on the cover (usually on the inside of the cover, though sometimes it is printed ...

...a defective air flow meter? Engine codes are; PO 110 Intake Air Temp, PO 100 Mass Air Flow, PO 105 MAP/Baro sensor. Is there any way to test these sensors without a lab scope? couple of possible ...

...the crank sensor andhow can I check it? 9/10/08 Starter Relay Part 10/4/08 Battery $129.99 6/13/07 Map Sensor Part Thanks in advance! 1 hour ago - 3 days left to answer. Could very well be a

...replaced mass air flow sensor wiring 2) he replaced throttle position sensor wiring 3) he repaired map sensor wiring and for these he said it took him about 2 days of work and charged me a total of ...

PO106 code GM what is that P0106 - MAP/Barometric Pressure Circuit Range/Performance Problem The Powertrain Control Module (PCM) uses the Manifold Absolute Pressure Sensor (MAP) to monitor engine load

IT IS NOT WORKING CAN I FIX THE MAP SENSOR FOR THE ELANTRA 2001 Run this diagnostic Test Procedures  1. Check if DTC P0110 is set in addition to DTC P0105 or P0106. If DTC P0110 is set, go to ...

code p106 Using a scan tool, watch the map sensor value with the key on, engine off. Compare the Barometric reading with the MAP reading. They should be roughly equal. The voltage for the MAP sensor ...

What is p0106? Hi there:This is a MAP sensor code (manifold absolute pressure). the code is for performance. you need to check the sensor and make sure its pluged in, and that the vacuum hose going to