2001 Mitsubishi Eclipse Spyder "engine wiring 2003" Questions

I have a 2003 Mitsubishi Galant. recently it has started to sputter, usually between 45 and 55 mph. I changed the plugs and wires, there is no check engine light and no smoke. Any ideas? Fuel filter

...engine management electronics if improperly connected. Never use the ECM (PCM) harness as a supply for 12 volts or ground. Conversely, never supply 12 volts or ground to the ECM except from the ...

Engine misfires under load. My 2003 Mits Eclipse, 4 cyl, 5 spd trans, will misfire when I step into the gas pedal. It seems to do ok when the RPM's are above 1500, but to take off from a stop I must ...

...letting fuel pressure in the injector rail go too high and causing an over-rich mixture and engine flooding (symptomatic of ALL plugs being wet). Once the engine is "flooded" it is sometimes ...

...2003 engine. How do I connect new harness? Changed wire harness old one had cable and two wires at transfer case speedometer, new harness has three wire plug. Not sure what to do with the difference ...

need to find wiring diagram for engine comparetment 2003 2500hd 6.o. have a broken ground wire from engine firewall The groun wire goes to a bolt or nut on engine.

engine now it will not start it turns over but will not start. ford focus 2003 remove the plug wires from thier location . next remove the plugs so water will fall into engine. crank engine with plugs

...engine light 2003 PT Cruiser - 2 weeks ago check engine light said misfire on cyl #1, so we changed the plugs. Now I am getting the same message again. Do I just need a coilpack for cyl #1? Use the ...

engine mechanical fault ( head gasket , cracked head , bent/burnt valves) ---wiring (HT lead, distributor cap or individual coil)--ignition / fuel ( injector and wiring)ECT/MAF sensor---ECM Go for the

...Or the Service Manual. this one is good and free! https://tearstone.com/2003-2005-eclipse-factory-service-manual/ Engine Electrical https://tearstone.com/eclipsefsm/GR00001600-16.pdf