2001 Mitsubishi Eclipse "tom start stopped working" Questions

...start and finally it works. When ever I slow down, the engine seems to stall and my powersteering locks up and my lights in my dashboard light up. When ever I am slowing down or stopped at a light, ...

...has stopped working what do I do? Order a new speed sensor and make sure that you heed the recall notice for a fuel line defect that WILL start an engine fire eventually. Mine burned. Buy a TOM TOM

...registered nothing. They all just sit at e or 0. Approx 20 miles later the car died. It will still turn over, but won't start. If you have a chance, please respond to [email protected] Thanks,

stopped working. after turning off /on the car it continued to work fine then it started up againg. turned it off/on and it continued to work fine, what could be the problem? Assuming it is not a heat

...start from a stop Hopefully just an issue with the belt itself, perhaps a bit old or improper tension, allowing the belt to slip. I'd change the belt out as its slipping has not been good to it and ...

...start up and it works again for about 10 min i have check the hyd oil and its full . the other thing you can still drive when it locks up!! just can operate the lift or tilt . the emerg lower works ...

...Tom and I am here to help you. I will start with the easiest fix for you and if that does not work, we can go from there. You should have a carburetor system. On the carburetor is an idle control ...

...working through wiring schematics and only common point I can find is the BIU. Any thoughts or suggestions. Unfortunately, nearest Subaru dealer is about 2 hours away. Thanks, Tom Hanaway Sounds like ...

...working as in the spring etc...Anyone out there any ideas..I am giving up trying at this stage...Tom Hi Tom, Sounds like your car may be running in limp mode. might be worth a diagnostic check and ...

...start reading again. Odometer, speedometer, gas gauge. This should do it for you. There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over ...