...mounting bracker screws. These are located on the side of the bracket that houses your stereo. 4) slide the radio out of the instrument panel and disconnect the wiring harness and antenna cable. 5) ...
...stereo and i am going to get one but it doesnt look like there is any mounting brackets for it and it doesnt look like there was any. how do you mount a stereo visit www.crutchfield.com they sell ...
...stereo Remove the ash tray, if I remember correctly there are three or four screws that mount the ash tray bracket (two are vertical and require a very short screwdriver). WIth this bracket removed, ...
...stereo mounting bracket. One screw is on the bottom left corner, the other screw is on the top right corner. Each screw can be removed with the 10 mm socket and drive. 8 Pull the factory stereo from ...
Question about Mercury Cars & Trucks
...mercury Cougar I have a 2002 that I just purchased and it has these brackets mounted next to the stereo I want to remove. I need to remove the face around the stereo. ...
...an inquiry. If you are installing a bracket, it is a good idea to indicate what it is to hold. That said, maybe this video will be of help: How To Install Car Stereo Aftermarket Mounting KIT GM ...
...stereo and that bold is ran through a hole on the bracket and there is a nut or a cap on it to prevent theft.... There should be two holes on the front of the stereo on each side, you insert the two ...
...center stack? Remove the pop in bezel. Look at the front of the stereo and see if it has two small holes on each side. If so you will need a stereo release tool to slide it out for the mount
...mounting brackets to your new stereo. Cut off the big wiring harness (unless you're lucky enough to have a replacement stereo that accepts the same kind). Connect the wires to the wires on your new ...
324 questions posted
Usually answered in minutes!
236 Questions
156 Questions
182 Questions
132 Questions
127 Questions