...intake air temperature sensor. The sensor is built into the Mass Air Flow sensor near your air filter. Pins 5 and 6 (wire colors brown and red/blue respectively) of the MAF connector are for the air ...
MAP sensor Location I would like to know where my MAP sensor is located on a 1995 Mits Eclipse GS 2.0 (non-turbo)? Its located on the intake manifold near the goooseneck
were is the knock sensor on a 2.4liter Knock sensor is located behind your valve cover on the lower intake manifold.
Question about Mitsubishi Eclipse
Intake air temp sensor fault. 14 Throttle position sensor (TPS) fault. 15 Idle speed control (ISC) motor position sensor fault. 21 Coolant temp sensor fault. 22 Crankshaft position (CKP) sesnor fault.
sensor is on the back of the transmission. The easiest way to get to it is to remove the battery, battery tray, and intake tubing from air filter to intake manifold. Once all that is out of the way if
...sensor is inside the distributor pin 5, 6, 7, = 5VDC signal, 100ohm ground, B+ 12VDC. If this is bad, the vehicle will not run, its protected by the MFI relay and a circuit in the PCM. Your most ...
...sensor) its located on the end of your intake. it reads the position of your throttle and works with your ECM, and the O2 sensors to control your air/fuel mixture. if its running rich and not burning ...
Question about Mitsubishi Eclipse
...disconnected, damaged or the wiring to it is damaged. If you have installed custom/performance intake then that would be your issue, if not then you need to check the MAS Airflow sensor and
Question about Mitsubishi Eclipse
intake manifold area or where you suspect a leak and if the rpm's increase , that's it.Use the carb spray sparingly and don't go overkill, if you know what I mean. Good luck I can only offer these few
947 questions posted
Usually answered in minutes!
696 Questions
360 Questions
344 Questions
319 Questions
306 Questions