1995 Mitsubishi 3000GT "size socket harmonic balance" Questions

...size socket to fit the nut in the middle of the crank. remove the driver tire and all the plastic trim. With the front of the car safely up on jack stands and the hand break applied you should have ...

...size of the socket that fits it. If you don't have a full set of sockets and wrenches, doing job is impossible. If it is oversize, and I don't think it is, you can get larger specialized tool from ...

...socket,think its 19mm, or 3/4 " on the center crankshaft bolt, with a good size breaker bar, wedge the breaker bar in between the suspension, and drive axle, to keep the breaker bar from spinning, ...

...size to remove a harmonic balancer from a ford sport trac Most fords are 15/16 inch. butyou didnt state the engine size. Youll also need a harmonic balancer puller and most parts stores can rent you ...

...socket to remove the retaining bolt from the harmonic balancer. Once that is removed you will need to use a special tool you can borrow or rent from Auto Zone or O'Reilleys auto parts store to remove ...

...harmonic balancer remover, screw driver, hammer. a piece of pipe the same size as the outside dia of the seal and a hammer along with a selection of spanners and sockets to remove the fan belt and ...

...harmonic balancer on a 1994 honda accord lx First, look at the direction the balancer turns. Remove the belts. Put the proper sized socket on the balancer bolt and, install a breaker bar into the ...

...size of the bolt head itself. Too bad that someone not familiar with Acuras didn't answer. It's metric of course, usually between 17-21 mm socket for those bolts. You will just have to try a few to ...

...size socket should I use for the small bolts if I have to take the, out first. Thanks, the socket will be metric size and it could be European metric which means that the socket size will be one off ...

...size socket that won't come in a regular socket set and you would be better off using 1/2 inch drive instead of the regular 3/8. You will also need to get a puller to pull it off the crank. The ...