Question about Mitsubishi Mighty Max
...unscrew.Its a bit hard ,cause the lock has not disengaged and sometimes u have to replace the screw.remember u have to remove all the panel to access the esl,which u can then unscrew.ive done this ...
...Unscrew and pry. Pop the bottom. Lift it out. Let it hang. Find the solenoid. Unplug. Hang the door cover. Drive to the parts store with a loosely-hanging door cover. Replace the solenoid. Use a ...
Question about Mitsubishi Mighty Max
door switch. It has a lock nut for setting the height of the pushbutton. Unscrew the switch. tighten the nut. test. Unscrew the switch. tighten the nut. test. Unscrew the switch. tighten the nut. test
Question about Cars & Trucks
...use a lock nut on the element carrier and you need to loosen of the lock nut and then unscrew the element out . Remember there will be lots and lots of water that will run out as well ( probably
to loosen by the pump. this is a lock nut. then you can unscrew the sensor. if there is no room to unscrew it, you have to remove the pump. some times it is easier to remove the bracket the pump is on
...filler cap on my 1992 S10 V 6 engine.What is the secert? No secert, get some big channel locks and unscrew, last person to put it on put it on a little to tight. On mine it does not unscrew. You
...Unscrew the door handle/pull with a phillips screwdriver (2 screws) From the bottom of the panel, pull the panel firmly toward yourself. This will cause the plastic anchor locks to release (or break ...
Question about Cars & Trucks
unscrew the lock section lefty loosey and then with a slight pry with small screwdriver entire front cover will pop off , this exposes the screws into the door , remove them an lock will come off door
how to remove crank shafe gears can not unscrew the nut. is ther something im not seeing?i tried with a pipe wrench backup ,scocket brackerbar wit a cheater pipe helpgoing for the oil pump shaft its ...
...out, disconnect wire to headlight and then unscrew lock on the back of the light housing, remove bulb. install bulb, lock bulb in housing and install the 2 flat locks on the back of the
122 questions posted
Usually answered in minutes!
135 Questions
77 Questions
75 Questions
62 Questions
46 Questions