I need a workshop manual for a mitsubishi L300 van 1990 model need to find mixer screw please The mixture screw is located in a resessed hole just above the therma start plate at the rear of the carby
1988 daihatsu charade carburetor what is the proper gas-air mixture? I find it hard tuning my car. Do I need to overhaul my carburetor? If we are talking the three cylinder CB23 engine the mixture ...
1988 Toyota corolla Ae82 5spd hatch what's the factory set point for the carby air/fuel mixture screw?. Iv had to replace the carby due to crack but the new used one is not set right and I can't seem ...
Question about Cars & Trucks
have question about engine noise at switch off kohler 20hp.the engine only makes this knocking sound when its hot and only when I switch it off otherwise its fine. possible run on or detonation from a
The carburetor is running too rich and fouling the spark plug. The idle on this 7hp engine also surges up and down, and doesn't seem to rev up to peak rpm. There is no idle mixture screw to adjust. ...
I am lacking power and need to adjust my carburetor I have adjusted the timing with a light, installed an electric fuel pump and installed a new carburetor about a year and a half ago. I need to know ...
fuel mixture setting gday is there an set position for the mixture adjustment screw?what is the best way set it and what is the best way of cleaning out the carby without removing it from inlet ...
i have just done timing on my ute would like to know how many turns does the mixture screw have to be wound out on carby once it is screwed all the way in. Its been using a lot of fuel. To adjust the ...
Question about Mitsubishi Minivan
1990 cressida over revving. where is idle screw on carby? need to find idle screw or mixture screw as car is over revving It sounds like it may need more than just an adjustment, the mixture screw is ...
Question about Nissan Cars & Trucks
got 308 v8 in nissan patrol running 600 cfm holley running to rich is carby to big get it jetted right and it will probably pass 308 would work best on a 450 -550 holley running rich could be float ...
151 questions posted
Usually answered in minutes!
997 Questions
851 Questions
799 Questions
747 Questions
704 Questions