2006 Chevrolet Trailblazer "install rear turn signal lamp" Questions

...rear fuse box. The BCM - body control module controls the dome / courtesy light's . The body control module (BCM) monitors the courtesy lamp switch signal circuit in order to determine when the ...

...rear of the new light. Place the new light in the headlight housing. Position it so the embossed number in the light lens is on the top. Place the retaining ring over the light and install the ...

...rear of the headlamp assembly Install the headlamp REMOVAL PROCEDURE Open the hood. Remove the headlamp. Rotate the bulb and socket counter-clockwise in order to remove the bulb and socket from the ...

...rear window wiper operate normally? -- YES - Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems NO - Go to Step 3 3 Install a scan tool. Display the liftgate control ...

...Tighten the tail lamp nuts to 10 N.m (89 lb in). 4. Connect the tail lamp electrical connectors. 5. Install the rear compartment trim panel (4) to the vehicle. 6. Close the rear compartment

...Install the rear combination lamp assembly to the vehicle and the seven nuts. Connect the rear combination lamp assembly electrical connector. Install the rear end trim panel and the luggage ...

...enough to remove the two lamp socket and wiring (13410) and remove the rear lamp . Replace miniature bulbs , if necessary. To install, reverse Removal procedure. Tighten nuts to 5.2-7.2 Nm (46-63 ...

...Install rear combination light and 2 screws. Install 2 screws. Connect electrical connector. Connect battery negative cable. 2004 (Late Production), 2005-2009 To Remove: Turn Signal Lamp Disconnect ...

rear turn lamps are grounded at G301 and G302. Turn Signal Lamps and/or Indicators Inoperative 2 Turn the ignition switch to the ON position. Place the turn signal switch in the LH and RH on position.

...INSTALL a new SJB. REFER to Section 419-10 . B2048 Left Rear Turn Lamp Circuit Short to Ground For Mountaineer, Go To Pinpoint Test M . For Explorer, REFER to Stoplamps in this section to continue ...