Diagram 1 Did you perform the Diagnostic System Check - Engine Controls? -- Go to Step 2 Go to Diagnostic System Check - Engine Controls 2 Start the engine. Seal the evaporative emission (EVAP) system
...Fuel lines have the same problem. These are made out of steel and rust fast due to calcium chloride used on the roads in winter. Unless you're familiar with routing and installing connectors on these ...
...fuel pump prime wire terminates within the vehicle. "????? what the hell?......first you're talking about a 2.5 (4 cylinder) that's in (eithier) a S-series Blazer/Jimmy, or p/u............did you not ...
Question about Chevrolet Colorado
...diagram? working on rebuilding and no hoses are connected to the carburetor. Not sure where they are connected very very old post no engine stated, nor country there are 12 vacuum setups, just in USA ...
...diagram, refer to the Wiring Information. Theory of Operation The Evap Purge Monitor tests the integrity of the hoses/tube between the throttle body/intake and the fuel tank. The monitor is a two ...
Question about Chevrolet Colorado
...fuel mixture to combust, and causes higher cylinder compression. High compression results in high temperatures and high NOx. Keep in mind this problem is usually seen in vehicles with over 150,000 ...
fuel built up and was ignited at the wrong time, because the ICM was not firing when it was supposed to. It resulted in blowing out the exhaust.IMPORTANT NOTE: I am not a fan of bench testing ICMs and
946 questions posted
Usually answered in minutes!
827 Questions
379 Questions
87 Questions
5 Questions
17 Questions