Question about Chevrolet Impala
How do I fine the wiring schematics for the coil packs module on a 2005 Chevy impala? It has some melted wires need to fine where they go. So I can rewire it. Need the wiring schematic for this. Go to
Question about Chevrolet Impala
2006 Chevy impala. I can't find an AC compressor bypass pulley for it. Does anyone even manufacture a pulley for an 06. If not are there any bypass pulleys that are interchangeable with an 06 impala? ...
PO 341 code on 2002 chevy impala Hi, This P0341 code basically means that the powertrain control module (PCM) detected a problem with the camshaft signal. The camshaft position sensor (CPS) sends a ...
...coils, coil packs, wires, distributor, distributor cap, and rotor. Anyone of these can cause a vehicle to not spark. Check everything you can. Make sure the rotor is spinning and make sure the ...
Question about Chevrolet Impala
What is causing my coil packs to burn out and melt repetitively on my jeep liberty 03? for coils to burn or melt indicates excessive current flow through them have voltage checks done wiring as there ...
Question about Cars & Trucks
melting center ignition coil and killing ignition module,car has new coils,plugs,wires,ignition module and pcm....still does the same thing...any ideas or common problems I have not heard of yert? You
Question about Chevrolet Impala
1995 Jeep Grand Cherokee Laredo - not getting a spark at the coil not getting a spark at the coil - coil is brand new...engine will turn over... assuming its a 4.0 liter straight 6 the crank sensors ...
Question about Chevrolet Impala
...out. It ran for 5mins then shut off and smoke was coming from under hood. I checked and one of the coils was melted.I replace the coil and cleared the codes but the car won't start. I am not getting ...
...oder and a light that said TCL off came on. I looked under the hood and u can see one of the coils melted . What TCL off mean? what caused the coil to melt ? I have never heard of this problem ...
no signal to coil found some melted wires on harness. peeled apart and taped. will this work or is the wiring bad since it melted together Yes melted wiring is a hazard. Replace.
2,207 questions posted
Usually answered in minutes!
2,177 Questions
1,746 Questions
1,386 Questions
1,452 Questions
1,181 Questions