2004 Chevrolet TrailBlazer "rear blower resistor" Questions

rear a/c module is located on the passenger side in the very back underneath the plastics and bezels in the back. there is a blower resistor module that controls the fan speeds and recieves input from

...blower motor doesn't work but works in rear I have a an 02 LTZ with the climate control and I am not getting any air movement from the front vents at any level but the rear controls behind the ...

...blower motor assembly. There are 7 slots for the plug and each have a different function such as one wire comes from your switch to engage low speed the next for the next setting and so forth. Of ...

...,so if its works with an earth then its either the reostat or the control switch The rear ac blower motor works fine UNTIL the ignition switch starts the engine. Then the rear ac blower motor

...blower motor under the passenger side of the dash. It is usually held in place with two screws that you will need a 5.5mm socket for. Not under the dash.... Sorry the picture is small but it is too ...

...is wrong underneath the truck...please help!! It could be a bad rear blower motor, or resistor? theres a lot under the truck that could make noise, have a repair shop check it and make

...setting for the blower fan on a 2004 trailblazer Check fuse #44 in rear fuse panel. Also did you inspect the connector that the resistor module attaches to? Sometimes the contacts or wires get

...blower (heater) for 2002 trailblazer heater will not work and i have replaced motor The relay is part of the control module. But you should first check the fuses, #35 fuse in the underhood fuse panel ...

...rear vents ? Do you here the Auxiliary Blower Motor running ? if you place the auxiliary blower motor switch in each speed position does the motor run at all.? If the blower motor doesn't run you ...

...blower(0.6ohms). I don't know what else I can do? If it has rear heat / A/C then no, the resistor control is done by the rear control head, located in the rear of the center console. You will need to ...