2004 Chevrolet TrailBlazer "2003 replace rear wheel" Questions

replace the seal on the rear 2003 Chevy Trail Blazer 2 wheel drive. I was told I need to replace the seal on the rear differential, that it is leaking. How can I know this for sure? look under the car

...been known to hang up, try pulling fuse #48 (4WD) in the rear fuse panel located under the left rear seat. Reinstall fuse and see if everything works OK, if not, you probably need to replace the

2003. just change rear brakes pads. while driving one of my rear wheels get so hot that there is a smoke coming out any body has a clue why? Just a guess, but maybe something is not put together right

rear end of the trailblazer. I have already replaced the outer wheel bearings along with the outer seals and gear oil. It's been a week since this has been replaced. It's still making the noise. Would

rear wheel bearing replacement on 2003 escape part is about 38 dollars ( frt wheel dr ) and must be pressed into the rear knuckle assembly.. if you dont have a press you can remove the rear knuckle ...

...you have the tools to do the job Here is how to replace rear wheel bearing hub assembly on 2002 - 2006 Nissan Altima w/o ABS: How To Replace Rear Wheel Bearings Hub On 2003 Nissan Altima ...

...replace the rear wheel hub on a 2003 Kia sedona. All I can find is directions on front not back. Wheel Bearings Print Adjustment 2002-05 Models Before servicing the vehicle, refer to the precautions ...

...replace the front wheel bearings on a 2003 ford focus. remove the hub and spinle ,tie rod end ,axle nut.ball joint,and seperate from strut and then have new bearing pressed in...or rent a bearing ...

...2003 Mustan Cobra. I was hearing a squealing noise wich seemed like it was coming from the rear end. I took it to a shop called Griffin Brothers. They drove and said that my u joints were bad. They ...

...rear wheel bearing on a 2003 pontiac grand prix. Can't get it off. the rear hub and wheel bearing assembly is sealed-for-life and must be replaced as a unit. it is secured to the knuckle w/ 4 bolts. ...