...out board remove the wheel & remove the brake assembly go back the the access area and remove the clip that holds the axle in , then pull the drive link or axle out you can then replace the seal
...holds the drive shaft in place in torn apart from havey exceleration and spinning the tiers. I need to figure out how to take the bearing off the drive shaft but the drive shaft that is int eh truck ...
drive shaft ? I need to replace the front drive shaft and am not sure how to do so? Mark the drive shaft postion to the transfer case and front axle. Remove the bolts/straps from the transfer case and
Question about Cars & Trucks
...holds gear box drive shaft in place can't put gears in place, long bar hanging from gear box replace the long shaft in the right lever and use a split pin to hold it in pace . There was probably a ...
Question about Nissan Cars & Trucks
drive shaft popped out or the clutch has gone. might still look attached but it will be disconnected in the dif. push it back in. or remove completely and replace the circlip as this is the only thing
Question about Chevrolet Colorado
...drive shaft? Has a double shaft with a bearing in the middle. Bearing has a square frame around it.Has 3 u-joints on the drive shaft. The shaft is removed in one piece. You first locate the two bolts ...
...drive shaft on a 1999 cherokee I have the four bolts off the U-joints at the back of the driveshaft but I still can't get it unhooked. It looks like there are 2 metal pieces holding it in place.... ...
...drive shaft. To place back in original position. Remove the u joint cap retainers. Spray some lube on the tops of the caps,for ease of removeing from the shaft ilets. Use a vice or a c clamp tool to ...
...Anyone know what the part is called in the center of drive-shaft that holds it in place & keeps it from knocking (located directly under gear-shift console) Thanks! It is called a, carrier
...drive shaft how to pull out the right front drive shaft if it was jammed? The shaft jointed to gear-box leaved inside. snap rings hold these shafts in so they simply pry out. the ring is round and ...
667 questions posted
Usually answered in minutes!
827 Questions
587 Questions
87 Questions
5 Questions
17 Questions