1998 Chevrolet S-10 Pickup "torque converter hard turn" Questions

torque converter holds lots of fluid. So drain the pan and measure the amount of fluid that is removed and put the same amount back in. Another way is to disconnect the return line from the cooler and

...when engaged to the flywheel. You can inspect the the flywheel ring teeth by removing the torque converter dust shield off at the bottom of the transmission where it meets up to the engine. Good ...

...torque converter was properly seated on the input shaft of the transmission. In oder to do this you need to spin the torque converter and push it into the transmission so as to spline the torque ...

...torque converter on a D21 1990 pickup Flexplate to torque converter bolts NISSAN D21 OLD. ENGINE TOLD. 2.4l OR 3 liter. (USA car?) THE SERVICE MANUAL COVERS ALL THAT. OLD OLD PU staged always cross ...

torque converter replacement yesterday. picked it up today and it steers squirly. the steering wheel turns hard at center, has a a clitch (bump) as it begins to turn left. to correct the steer from on

...TORQUE CONVERTER WILL KEEP CAR FROM CRANKING IF TORQUE CONVERTER REMAINS LOCKED UP.CHECK BRAKES LIGHTS TO SEE IF BRAKE LIGHTS WORKING.BECAUSE WHEN YOU APPLY BRAKES THE TORQUE CONVERTER SUPPOSE TO ...

after instaling a used transmision engine hard to turn over to instal tork converter nuts the torque converter is most likely not installed correctly

...torque converter into a regular (manual type) clutch until you make a significant change in speed or throttle position, at which point it 'unlocks' and turns back into a regular torque converter. Not ...

torque converter has had a catastrophic internal failure. Remove the torque converter nuts/bolts and slide it back into the trans. Does it still turn hard? If yes, you have isolated the problem to the

torque converter i already fix the torque converter check the pump etc but its not turning and it is hard please help What is not turning? The torque convertor stator?