1998 Chevrolet S-10 Pickup "s10 chevy motor mount" Questions

...Chevy S10 4.3 into a 1987 Chevy S10 2.8 engine compartment. Would the transmission match up to bolt up to the engine? Have both vehicles. The 87 body is great with a weak engine. The 89 body is shot ...

do i have to pull engine to change oil pump on 1997 chevy s10 4.3L if you can get oil pan off  ,no  you may have to unbolt  motor mounts and lift engine up to get clearance.

...chevy s10 trany if my trany mount is old and worn can it harm any thing? no not realey but it would be good idear to re place it . ok yesa it will hurt alot it will put tramendus stress on the trany ...

...chevy s10 pickup 2wd, do i remove the trans. protection plate or take off the exhaust cross piece? you take the exhaust off, u don't have to remove the trans for any starter replacement on any S10 if ...

...chevy s10? The starter is unhooked, but we can't get it out! It's stuck! You have to disconnect the right motor mount and jack the engine up a little. I hope this helps you, and I wish you luck on ...

...chevy s10 tahoe pickup (4.3 liter v6). when i accelerate i can see the shifter moving a good amount. i dont know much about mechanics but im sure thats not good. also if i punch it from a stand still ...

...of the Chevy s10 by removing motor mount bolts and transmission crossmember bolts? You may have to remove the cross member & also drop the front axle some, if you have 4 wheel drive,for

...chevy s10 blower motor resistor My blower motor only works on high and from the research I have done they say to replace blower motor resistor. Was wondering if someone could tell me where ...

...chevy S10 pickup Remove the coolant reservoir. Remove the rear coolant recovery reservoir mounting stud. Disconnect the cooling tube from the blower motor. Disconnect the electrical connector. Remove ...

...chevy s10 what engines will fit into my 1994 chevy s10...as of right now it has the 4.3 vortec with automatic tranny it is 2 wheel drive...i need to use my same tranny though i think its a 700r Jeff ...