1998 Chevrolet S-10 Pickup "cross shaft chevy" Questions

...Chevy S-10 V6 Vortec engine 4X4 Changing flywheel I have teh inspection plate off, the cross members loose, the trans lines are off, the drive shafts are off, and I'm stuck there. separate the trans ...

...Cross Shaft Pin out but its seized to the spider gear. i have tried pounding it out even with an air chisel and heat but nothing seems to be working. now i no that i have to replace the spider gears ...

...shaft then you unbolt the exhaust behind the Cross-member so the trans will come down enough to get to the top bell-housing bolts. and undo the shifter from the drivers compartment, once you get past ...

...Chevy s10 4x4 engine 4.3 Get yourself a service manual. first secure the vehicle on Jack stands remove both drive shafts disconnect linkage from transfer case unhook wiring from transfer case, if ...

...cross shaft and remove the shaft. push the axle in and remove the "c" clip on the axle end. It can then be pulled out of the housing. Reverse to install. Don't turn the gears while toe cross shaft is ...

...bolt that holds cross shaft in place. Slide cross shaft out. Push axles inward and remove C-washers. Remove axle shafts being carefull not to damage axle seals. Question Why are you taking this

...cross into either the shaft or the yoke and carefully put on one new cap. Now, with a u-joint tool, vise, or big C-clamp push that cup in past where it would normally stop (1/4 inch past). By doing ...

Same retaining bolt in center section needs to be removed to allow cross shaft to come out. Same technique in removing spider gears. Same "C-clip" retainers on axle ends. you shouldn't have any issues

...cross member of a tranmission ? remove bolts both sides of frame unbolt trans mount jack up trans slide out you may have to remove drive shaft to bring trans up high enough or if lucky you will get ...

...shaft CCW and CW by hand to check for any play in the universals, and listen to see if you can hear the 'clunk' sound. Universal joints are the cross shaped items with round caps at either end just ...