...starter form a 98 s-10 how ??? 1. open hood 2. remove batt. cables 3.remove batt. cable on starter starter is located lower pass. side of motor (also might be a couple of other wires connected to the ...
...98 s-10 has new fuel pump, new crank censor, another computer, and has 2.2L. truck won't start, and run. The security light is on and stays on when attempting to start truck. Also, truck did crank, ...
...starter on a 98 S-10 pickup but no room to even see all the bolts to take out to remove the starter. You'll need swivel sockets and racket extensions to angle in and around to get at the bolts. A ...
...98 chevy s10 i replaced my starter and cylinder 1 is misfireing i figured its my timeing that is off. how do i fix that? No way replacing the starter would change timing. Unless you removed the ...
how to remove a starter from a 98 4x4 s-10 from what?
...starter motor, or a small screwdriver driven socket to remove the screws holding the lower part of the dash together (below the steering column)- I hope this was helpful, I ran into a lot of problems ...
...starter. If removed, install the intake manifold stay and tighten the retainers to 18 ft. lbs. (25 Nm). For 1995-98 2.4L engines, install the air cleaner and air intake hose. For 1995-98 2.0L turbo ...
...2.4L engines, remove the air cleaner and air intake hose. If equipped with 1.8L engine, remove the bracket on the lower side if the intake manifold. Detach the starter motor electrical
...starter relay on 98 ford explorer starter relay is under hood on the drivers side fender area. Disconnect the battery ground cable (14301). Disconnect the starter motor solenoid relay switch wiring. ...
...98 buick lesabre..i have the car jacked up on ramps but am confused to how to get the starter out The starter is on the front of the engine, towards the transmission. There are only two bolts and two ...
2,062 questions posted
Usually answered in minutes!
904 Questions
790 Questions
747 Questions
686 Questions
620 Questions