Question about Chevrolet Malibu
...BLOWER MOTOR CAN CAUSE YOUR PROBLEM, OR A BAD RESISTOR. THERE IS NO REAL GOOD WAY TO CHECK THE RESISTANCE OF THE BLOWER MOTOR. hi you probely have a draging blower motor. if it pulling more than 25 ...
...BLOWER MOTOR COULD BE FAULTY OR THE SPEED SWITCH COULD BE THE CAUSE LOAD TEST THE MOTOR ON IT'S OWN TO SEE IF OVERDRAWS EXIST IF NOT CHECK OR REPLACE THE SWITCH THE RESISTOR ARE KNOWN TO GO BUT ...
blower (only speeds 3-5 will work) -Front coil springs breaking -Front brakes wear funny, excessive wear -Moisture in headlight housings Most likely it is not related to the switch. More likely is the
Question about Chevrolet Malibu
...blower motor quit. Is there something wrong with the temperature control? The problem was the motor. Replace the blower motor and resister and it should be fine. If the blower motor resistor is ...
Question about Chevrolet Malibu
...blower motor quit working. Control Module? Buick centry with manual AC-heater control. I turned the fan control knob to high and immediately noticed an electronic burning smell. No output from the ...
Question about Dodge Cars & Trucks
...blower motor resistor and it burns out after running ok for about 10 to 15 mins. Could it be the blower motor itself? Blower motor speed reducing dropper resistor gets hot in normal use and it is ...
...blower motor quit working The blower motor would cut in and out and eventually quit all together. Have read people talk about the resistor. Can I test that? How can I tell what the real problem is? A ...
...blower motor electrical connector. If both power and ground are present, replace the blower motor. If power is not present, you may have a blown fuse, in which case your motor is very likely to be ...
The blower motor resistor is the culprit.Usually is located near the blower motor.Generally an inexpensive repair.However it is possible that the blower motor may have caused the resistor to burn out
...blower BURNED slightly in the process, and will need to be replaced all the way back to where they connect to the fuse block. (The wires may have been pinched or otherwise damaged somewhere, so they ...
1,551 questions posted
Usually answered in minutes!
1,306 Questions
1,257 Questions
1,067 Questions
997 Questions
1,026 Questions