...fan blade and try wiggle it from side to side. If there is movement the pump is most likely shot, you may have to take the belt off to get a better feel. Check the fan clutch too if that is getting ...
...fan shroud and tighten to 21 Ft./Lbs. * Connect the electrical connector * Clip the fan shroud to the radiator at the side panels * Install the fan clutch onto the water pump shaft and tighten in a ...
Question about Chevrolet Blazer
...inline nut CCW to tighten...30 ft-lb. Check that fan can be hand turned...CW.) Rest shroud over and onto fan. Replace radiator; remount shroud; reclamp hoses, and refill and air purge cooling
...fan from the clutch assembly. Installation is the reverse of the removal procedure. Tighten the components to the following specifications: you will need a special tool to remove #3 fan clutch. the ...
...fan out? YOU CAN RENT THE TOOL AT AUTO ZONE ITS A BIG WRENCH.OR IF YOU HAVE AIR TOOLS YOU CAN GET A AIR HAMMER WITH A FLAT CHISOL AND BURP IT OFF.TO LOOSEN IT, IT TURNS TOWARD THE PASSENGER SIDE.TO ...
...fan on the viscous drive. Install the bolts and tighten them to 187 inch lbs. (24 Nm). Position the mounting flange of the viscous drive assembly onto the pulley. Install the nuts and tighten them to ...
...Tighten water pump pulley, fan clutch hub bolts, and fan-to-fan clutch hub bolts to 16-24 Nm (12-18 ft. lbs.). Install fan shroud. -Install drive belts. -Fill and bleed the cooling system. -Start the ...
Tighten valve on radiator back up.There is a cover on most vehicles called a shroud.It keeps hands safe from fan blades.Locate and remove shroud bolts to loosen shroud.To remove shroud,fan may have to
...fan blade if it spins really freely you need a new one. Provide you have a fan clutch, and not an electronic fan motor sorry just have to put it out there some folks mistake a electric fan for a ...
Question about Cars & Trucks
...fan blade bolt for a tb320bv 1.Flywheel - 61 to 69 Foot Pounds 2.Pressure Plate - 25 to 33 Foot Pounds 3.Bell Housing - No specs found. I would say 25 to 35 foot pounds should be sufficient. Bolts ...
2,154 questions posted
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
982 Questions