1996 Volkswagen Jetta "beam axle" Questions

...the rear cross beam , you will have to jack up the vehicle and use axle stands , try oiling the pivot on the valve and at the same time work it with a pipe wrench , they will un sieze just work at ...

...axle beam. There is a check valve inside this pump to maintain pressure in the lines, especially on hot days, to avoid vapor lock. The fuel filter is mounted to the side of the reservoir. This filter ...

...and nut from the spindle , ( you might want to replace the wheel bearing at the same time due to the bad axle ) remove the axle bolts,, and shock bolts, from the axle beam. remove axle beam ...

...axle beam when I hit something, when I ran off the road the other day. and it made the rear weel tow out some.. just enuf where I cant drive it..the axle is just sprung and does not have any serious ...

...axle beam the car has 170000 miles in to it and it run as if its still new. U may be right if u balance and align the wheels this not supose to be going on and u should check ur wheel bearings too ...

...beam axle? Hi, I have a 2003 Nissan Maxima. My rear beam axle (shaped like an upside down "U" has a tube the runs through the middle. The weld broke on one side of the tube and is clanking when I ...

...axle beam. So first figure out which one you are talking about, then go look up that part on a parts store website or call a dealer. Rear axle beam will be a dealer or junk yard item, front drive ...

...axle swap for my international to make it easy to find parts for front axles (I beam axles ) for trucks are made by dayton, eaton . These axles were fitted to international , dodge , ford , chev. ...

...beam solid front axle, the castor is set by wedges under the springs on the axle. The camber is set by bending the front axle. If is an independent front suspension there will be adjusting wedges or ...

...LINK SUSPENSION IN THE REAR YOU WILL HAVE HALF SHAFT DRIVE AXLES SHAFTS. IF YOU HAVE REAR AXLES BEAM TYPE YOU WILL HAVE REAR SHOCKS AND REAR COIL