1998 Mitsubishi Diamante "1 engine" Questions

Ad

...engine shown. 1. Disconnect the negative battery cable. 2. Remove the timing belt. 3. Unplug the sensor connector. 4. Unfasten the two retaining bolts, then remove the CKP sensor from the vehicle. 5. ...

Ad

Question about Mitsubishi Diamante

1 Answer

...engine to the rear on the passenger side 1-3-5 Looking from the front of the engine to the rear on the drivers side 2-4-6 The engine has coil over plug with coils only on the drivers side. ...

Ad

Question about Mitsubishi Diamante

1 Answer

...engine rev if you depress your accelerator pedal?3)  On a scale of 1-10 (1=basic), how would you rate your technical understanding and ability?The above questions will enable me to help you ...

...1 is located on the top of the exhaust manifold on the radiator side of the engine. You will need an O2 sensor socket or a small 22mm wrench to remove it My service engine light comes on in my 2003 ...

Question about Mitsubishi Diamante

1 Answer

...1/2 quart of transmission fluid in the engine. It is high detergent and will clean out almost eveything. Run this for 15 to 20 minutes after the engine is warmed up. then replace the oil and filter. ...

...1 & 4 of the connector (using a suitable jumper wire) 3) turn key to 'on' (do not run engine) 4) any fault codes present, will flash the appropriate warning light on the instrument cluster. E.g. ...

Question about Mitsubishi Diamante

2 Answers

...1. Unhook the battery for a few minutes and then hook back up 2. From a cold start. Turn the ignition to the acc position for 20 seconds and then turn back off. 3.start the engine with no accessories ...

Question about Mitsubishi Diamante

1 Answer

...both on car and old alt, it really helps when refitting the new 1. then reversing the process to fit the new alt. if it's bottom of your engine then you might need to lift the engine, a lot of

Question about Mitsubishi Diamante

1 Answer

...engine is hot. Had the same thing. The didtributor was going bad. Lived with it for a few months finally it died. 1 year after replacing the distributor the problem started again. Glad I got a ...

...1 min to warm engine slightly. Repeated starts produces the same symptoms of start and die. If it does start idling , tends to cut out if accelerator pressed quickly. As soon as slightly warm , ...

Not finding what you are looking for?
1998 Mitsubishi Diamante Logo

145 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...