1997 Mitsubishi Mirage "1 engine timing" Questions

1.5L Engine: http://autorepair.about.com/library/firing_orders/bl-fo-6825.htm Click on the following direct Link fo rthe Firing Order/#1 Piston Diagram for the 1.8L Engine: http://autorepair.about.com

...engine replaced head gasket now it starts a bit on idle if i try to rev it it stalls and cuts off and starts turning backwards. if I remove a plug where there is compression a blow of air comes out. ...

engine bracket set a side remove top valve cover remove the spark plugs and turn the camshaft flywheel clockwise and bring # 1 piston at top dead center (the highest point) check the crankshaft should

...1 try to check your accelerator mechanism & wire tension to your engine carborator , 2 check your sensors for your speed control unit,cause it's working with depend on how much acceleration is given ...

...than -13.5 percent, or more than +13.5 percent, for 5 seconds. Have the O2 Sensor changed on the Right Bank, ( passenger side of the Engine, or where the # 1 cylinder is.) Good luck and hope this ...

1 mark on cap,easy to just set as above,crank engine,if no start, backfiring or it runs roughly,just stop,move them all around the cap by one but staying in the firing order of 1342.you will only have

...motor and a big bar with socket because the engine turns in the wrong direction as it points to the right ,So unless you have the right tools like a 1" air wrench with a nice air reserve behind it

...starts before the battery goes dead. personally i would like anything more than 650 cca. theoretically 1 cca per cubic inch of engine size is the minimum requirement ( by the book ) 14 or ...

...engine light was flickering for 1 or two minutes only.Evening time on engine start again light flickering and after stop to a traffic light light stays on .I stopped the engine 5 min . and afterwards ...

...1 spark plug and turn the engine over while you hold you thumb over the hole (2 person job). If it doesn't have compression then your cam timing is off. check for compression on all cylenders then ...