1997 Mitsubishi Eclipse "clips attach door panel" Questions

...door panel inside, you'll see the window where its bolted, just behind that dip down shape of the window where it attaches, you'll see another 10mm bolt, take those 2 bolts out, remove the two ...

...clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door ...

door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not

...clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to remove the bolts ...

clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.You can then disconnected the rod from the back of the inside handle

...clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door ...

clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps 1.Roll door glass down.

...clips to engage. If a clip will not engage, inspect the mounting hole behind the panel to make sure the clip is properly aligned. Install any panel-to-door retainer screws. If equipped with crank ...

...clips to attach door trim to door frame around perimeter of panel. If equipped, install screw to attach door trim to door panel behind inside latch release handle. If equipped, connect power switch ...

...clips on the inner door panel. Disconnect the lock and latch rods from the outside door handle and the key cylinder at the door latch. Disconnect the wire connector from the power door lock motor. ...