...shift gears. I then replaced the clutch 'master' cylinder - but I am still getting 'all' the same symptons. I probably haven't bled the system as well as I should yet (at least as far as opening the ...
...gear at high speed causes some grinding action below the vehicle...i have asked my friend and he said it could be the transmission fluid problem...could it be that or it's the clutch problem... any ...
turn motor off to get first or reverse gear. Other gears are hard to shift. Now what? Are you sure you have clutch plate in right? The plate is stamped or has tag on one side that says "flywheel side"
gear indicator light on my centre consle Remove the PRNDL trim ring. Remove the upper console panel. Slide the lower shift knob bezel downward. Remove the bolt and lift up on the shift knob to remove.
into gears just replaced the clutch. and i bled the clutch and now i cant shift into gears when i start the car. what is going on here? did you replace the clutch pressure plate and throw out bearings
shift into 2nd gear to avoid it. After that, shifting and acceleration is good. Just from dead stop, between 1-2 shifts. Replaced master and slave. Truck on, idling, fine. Rolling out of first, nasty.
...gear the second push. In the drive way it shifts into all gears just fine. If your able to shift with the car off sitting in your driveway but not able to shift once the engine is running then you ...
Question about Mitsubishi 3000GT
gear and move. Eventually it just didn't catch. Also, what is the estimated price range I should save? Your friction plate is kaput. Replace clutch system. Sounds like the pressure plate needs
Question about Mitsubishi 3000GT
...replace the clutch plate but but now it only has 4th gear check the joint where the shift linkage attaches to the shift shaft at the transmission....you either have a pin missing in the joint or ...
Question about Ford Cars & Trucks
...gear. there is a plastic part at the top of the transmission that wears out. It fits around the ball of the shifter. It is two pieces. You'll have to remove the floor plate and pull it up to access ...
113 questions posted
Usually answered in minutes!
128 Questions
112 Questions
121 Questions
100 Questions
96 Questions