2000 GMC Yukon XL "remove brake cable rear caliper" Questions

...Remove or disconnect the following: Wheel and tire assemblies Axle lubricant into a suitable container Rear driveshaft Parking brake cable Brake calipers Shock absorbers from the axle brackets Vent ...

...Remove retaining clip from the parking brake rear cable at the disc brake caliper. Release the tension from the parking brake cable and disengage the cable end from the parking brake lever on the ...

...Remove an Emergency Brake Cable From a Caliper Lift the rear end of the vehicle using a jack then place it on jack stands. ... Locate the rear brake caliper. ... Hold down the locking tabs on the ...

...THE BRAKE CALIPER.SWING THE CALIPER DOWNWARD AND REMOVE THE BRAKE PADS.TO INSTALL NEW PADS.YOU HAVE TO RETRACT PISTON INTO THE HOUSING BY ROTATING THE PISTON CLOCKWISE.PUT EVERYTHING BACK VISA

...cable from the caliper. Remove the brake hose bolt. remove the two bolts holding the caliper to the bracket. Remove the caliper. Install the new caliper and bleed the brakes.you should be good to

remove the rear calipers to change the brake pads? I changed the rear pads this fall, have you removed the caliper retaining bolts and the Park Brake Cable? I remember the cable being a pain and using

...remove brake fluid until the level in the container is less than half full. A turkey baster is a good tool for this. Put the brake fluid in the plastic container and dispose of it the way you dispose ...

...remove brake fluid to the midway point before proceeding. Raise the vehicle and suitably support. Remove the tire and wheel assembly. Pull down on the front park brake cable. Remove the front park ...

...brake to the caliper body assembly. Remove the sleeve bolt, then remove the caliper body assembly. Pivot the caliper body up to clear the rotor and then slide it inboard off the pin sleeve. If the ...

...REMOVE THE WHEELS.DISCONNECT THE PARKING BRAKE CABLE.LOOSEN THE THE HYDRALIC LINE.USE A BACK UP WRENCH TO HOLD THE GUIDE PINS AND REMOVE THE CALIPER BOLTS.LIFT THE CALIPER OFF THE CARRIER AND UNSCREW ...