2002 Ford Explorer "brakee sensor" Questions

ABS engages without braking ABS pump engages intermittently without braking You might check the rear Emergency brakes. The brake linings peel off the mounts and whirl around inside the E brake drum. ...

Problem with my cruise control and ABS light on 03 Explorer Hi, Well my cruise control was working perfectly, then it just stopped. It won't even light up in the dash. My back lights are all working ...

Sensor lights are on need sensor wire information due to abs light stays on after brakes changed on 2001 VW Passat sensor light stays on likely due to broken wire when brakes were changed

can a rear abs sensor cause the brake on that wheel to apply,smells like hot brakes when you stop Yes and No. When ABS get activated it gives a pulsation of fluid pressure to that wheel it detect

1998 ford explorer front brakes act like they are sliding on ice.At the same time the anti lock brake pulsation is going on. I'm told that perhaps the front wheel sensors have gone bad and are in need

I have a 1997 Ford Explorer with 240,000 miles. When you apply the brakes everything works fine until the car almost stops. The anti lock system starts to pulse when the car is braking for the last ...

2006 ford explorer. While driving and abs code, a picture of a wrench and the truck skidding picture came up. What do codes mean besides taking it in immediately!!!!? How much will this cost to repair

change brakes and rotos and abs light still comes on It doesnt have to be bad brake pads to turn the ABS lite on, it can be a bad ABS wheel sensor. It would be easier if you had a scanner to tell you ...

possible brake sensor problem, cannot engage into gear. column shifter. barely turn key over and then i can engage into gear, but have no brake lights. How do i go about fixing this. First off, check ...

Have similar problem after changing brakes How do you adjust or ensure that the sensor is in proper calibration? I have changed brakes for years but never saw an ABS sensor on this assembly. Just ...