...crank. If you hear a whirring sound inside the tank, the pump and relay are almost guaranteed to be ok. If the crankshaft position sensor has died, it will not tell the computer when to open the fuel ...
Question about Ford Mustang
...wires to coil pack in proper order? Double check it. No break in the PCV vacuum line, is there? Change out the crank position sensor and clean the MAF sensor. YOU TUBE will show you how. don-ohio
Question about GMC Cars & Trucks
...crank sensor at the front under the front crank pulley and it is in the correct installed position, you should not have a code for that,unless the wiring is defective or the crank sensor is
...change the crank senor, cam sensor or fuel filter/regulator?? (this is for others who may be viewing this problem) P1594 = charging system voltage is too high P0320 = crankshaft position sensor ...
Question about Cars & Trucks
changed crank position sensor, new plugs,wires and coil,car will turn over but will not crank, however its a manuel transmission plugs.wires.coil,crank position sensor, head gaskets Check plugs wires
...off the front crank pulley. The pickup you changed is the Camshaft position sensor and will cause hard starting but not a complete no start. A picture of the Crankshaft position sensor is
...change the crank sensor without removeing the exhaust header and oil filter adapter Hi Michael, The link below is a short YouTube video showing how to find a crank shaft position sensor on a (1998 ...
Question about Cars & Trucks
...crank position sensor circuit errors. These would imply a broken wire in the sensor cable or an incompatible sensor or bad new sensor. Or reinstall the original crank sensor and see if it will run as ...
Question about Cars & Trucks
...crank position sensor, or cam position sensor. Or the wiring and circuits to all the ignition parts. Often it is the crank sensor (CKP sensor)-The pcm must have this information from the crank sensor ...
...on a 93 Ford that it was bad and the coil wasnt getting any electricity while the switch was in "start" position. Most likely crank shaft position sensor. Or coil pack module, most likely crank ...
251 questions posted
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions