Question about Dodge Durango
...sensor+1+and+2 .. In the 2005 Dodge Durango with a 4.7L V8 engine, the Bank 1 sensors 1 and 2 are located as follows: - Bank 1 Sensor 1: This oxygen sensor is located in the exhaust manifold on the ...
PO152 fault Code 152 is for a problem with the circuit for the O2 sensor bank 2 sensor one. The signal from the sensor is too high.
Question about Dodge Durango
...code,replaced both 02 sensors, plugs r good, mp sensor good, tps good,new coolant temp sensor, new pcv valve and cleaned throttle body still runs bad and getting black smoke clean maf sensor going to ...
...code so hard to say, the location of the knock sensor is the lower section of the engine block, it is screwed into what would normally be a block drain plug, if u replace it u need to torque it to ...
...have a 2005 Dodge Caravan and my code reader says P0406 EGR position sensor high. Is it usually the valve or the sensor itself that is the problem? It is most likely that your egr needs to be ...
sensor, error code p0406 need to replace egr sensor, error code p0406 I have fixed the problem foe now. thank you What was the fix for the p0406 did you replace the EGR temperature sensor circuit high
...sensor is the problem, check the connector 1st for water intrusion or oil, if u do replace it then u must torque it to the proper spec into the cooling system jacket of the block or it will set ...
What is a P0339 code for a 2005 Dodge Durango crankshaft position sensor A CKT intermttent, this problem code means=== p0339--crankshaft sensor bad or a loose wire. have a good day!!
Question about Dodge Durango
...error code of P0038 P0038 HO2S Heater Control Circuit High (Bank 1 Sensor 2) It is located behind the catalytic converter, in the exhaust pipe . P0038 HO2S Heater Control Circuit High Bank 1 Sensor ...
552 questions posted
Usually answered in minutes!
2,049 Questions
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions