2003 Chevrolet Suburban 1500 "knox sensor" Questions

...knox sensor but i cant locate it in the engine the knock sensor is located under the intake manifold in the cavity between the two engine banks. be sure to apply a layer of silicone or some sealant ...

...knox sensor on a 1987 chevy r10 pick up truck it has a 4.3 6cy If you face the engine its on the right side about 10:30 to 11:00 O, clock slightly behind the distubtor shaft torward the fire wall you ...

...Knox sensor. I replaced the knox sensor when I replaced the motor. Ive done all the basic checks i.e. plug wires, cap plugs, injectors signal good. Can the tps send a signal to disrupt the functin of ...

replaceing the knox sensor where is the knox sensor located so I can check the connections? Do you mean knock sensor? well, it's located below intake manifold

location of knox sensor on 96 outback legacy 2.5 1996 Subaru legacy outback with 2.5. Where is the knox sensor located Here you go John.see diagram below

...knox' sensor's need replacement @ I have been told 'knox' sensor's need replacement @ nearly $700...????? Upper part of motor needs to be taken off, etc..if I don't replace the sensor, could bend a ...

...Knox sensor & or the Blue wire going to it if it is Grounded , the timing will not Advance, Knox sensor is there to detect knock then it grounds if it catches a Knock to Prevent Pre Ignition ...

...knox sensor. I have changed all four coil packs and plugs due to previous faults and the car was ok for 3 weeks, I now have the above faults but the car runs very well, is this just due to rubbish ...

...knox sensor HI, they are located under intake manifold. The first sensor is located in the front of the engine and the second sensor is located in the back of the engine. Remember to replace the ...

...knox sensor. Hello: Approximately 2 - 4 hours depending on the ability and experience of the technician performing the task. There are two sensors, both should be replaced. The intake manifold has to ...