the cover on the rear end, remove the 5/16" bolt on center carrier, push the pin that the bolt whent through out, thenp push the axle in, a c clip will fall out of the carrier then axle may be removed
...Remove the rear cover. Remove the 5/16 (8mm) bolt that holds the center pin and slide the pin out. Push in on the axle (from the outer stud/drum end). When the "C" clips fall out (inside of the ...
...remove the rear wheel bearing on a 2000 chevy suburban # 1500? yes, after the rear axle is removed you have to use a large slide hammer with a special attachment on the end to get it out and the ...
...rear end. Look behind removable panels for the connection. When found, remove the connection and scrape away any rust, then grease the bare metal, install a 'star' washer first, then the wire ...
...rear then this is cylinder #6.you may need to use a wrench to get the plug loose enough that you can remove it with you fingers.you may need to use the open end of the wrench or the closed end which ...
...remove the rear end cover to pull a clip, so that the axle will come out. At least you used to have to do that, might not have to anymore. You will need a book. But remove the bolts, Get a big chain ...
...TO GET OUT 99 CHEVY SUBURBAN. LESS THEN AN INCH i assume thru the rear cover? Remove cover and check for spider gear shaft pin being broke.While in there of course inspect all gears but pin most ...
remove rear end cover get a pan for fluid to drain into,there will be a set of gear's through the gear's on the right side of the ring gear there will be a pin about 13/4" in dim. and about 5" long at
...comes and goes when you accelerate or decelerate you may be dealing whit the ring and pinion needs adjustment or is going out, remove the rear cover and check for excess metal shavings,Hope this ...
326 questions posted
Usually answered in minutes!
550 Questions
469 Questions
461 Questions
355 Questions
338 Questions