1997 BMW 318 "new transmission seal leak until" Questions

Ad

Question about BMW 318

2 Answers

...transmission product and they are all about the same. Good Luck Hi, Using safety precautions, you will need to remove the drive shaft from the rear end, (4 U Joint nuts). Get a small container to ...

Ad

transmission casing). You can use old sockets drive new seals in, just be sure to pack new seals with some grease to prevent the small spring on the inside from falling out during installation. If the

Ad

transmission seal on a 1987 Wrangler? Is this a job that a hobby machanic can do on the car port? if you are talking about the seal at the rear of the tranny where the drive shaft goes into than it is

...transmission out to replace. Once down and out you can use a small flat head screw driver to get the old one out and then dry it up as good as you can. Place the new seal in place and then tap around ...

...new oil seal using the J 42067 seal installer or equivalent. Check to ensure that the seal is seated squarely in the bore. Install the flywheel. Install the transmission. Run the engine and check for ...

new gasket set for the transmission. Gaskets are not reusable. A gasket that was working fine previously could leak after reassembly. Carefully follow the recommendations from the gasket manufacturer.

...transmission . It is new and was just installed. Does it need to be slid in farther? It should slide in until it clicks into place. The end that goes into the tranny is splined with a grove that has ...

transmission. Its pretty easy to do you just have to remove the serpentine belt, and remove the crank pulley, then you can pry out the old seal with a pick or screwdriver, clean the area from dirt and

...A2) until ATF runs out of level hole -Install new seal on plug and tighten to 15 Nm (11 ft lb). ATF check is completed. CAUTION! Too little or too much ATF will adversely affect transmission

transmission damage due to low fluid, leaky headgasket that could fail at any stage, and that the thermostat had been removed and bolted to the engine. For a few months the car was running the best it

Not finding what you are looking for?
1997 BMW 318 Logo

509 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1996 BMW 318
1996 BMW 318

796 Questions

1999 BMW 318 ti
1999 BMW 318 ti

525 Questions

2002 BMW 318
2002 BMW 318

14 Questions

2003 BMW 318
2003 BMW 318

8 Questions

1994 BMW 318
1994 BMW 318

10 Questions

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...