1996 BMW 318 "change barrel plug" Questions

...barrel on my 1997 bmw 318i now it won't turn over,all lights come on but no crunk. Hi I presume you had this issue with the old ignition just spinning around and not starting the car? I had this same ...

...barrel to a plug underdash. the other end to the plug has two wires in it that are purple, and white. which send the key resistance to the security module. you can bypass this wire harness if you can ...

changed spark plugs AND HAD TO TAKE OFF THE ALTERNATOR TO GET TO BACK set of plugs. when replacing alternator hot wire touched the alternator casing and it arced, now car wont start You melted a ...

...change the key barrel or the tumblers, to remove the tumbler set put key in the switch, remove the beauty ring it just snaps on then stick a paper clip into the hole where you removed the ring or on ...

My 1.3i ford Bantum switch itself off. Specially when turning steering wheel and driving slow. I changed spark wires, plugs and coil but still the same. Everything by the look of eye is okay. Pls help

...barrel ( where you put the key ) you will see a connection with wires going to it normally a black or white round thing you can normally remove it if you locate the grub screw ( normally an allen key ...

...to loosen some of the build up....may need to be replaced..i cut mine open..truck ran fine ....i changed it and havnt had trouble ...

gasket on throttle body The idle of the vehicle is controlled by the idle air control motor located on the throttle body looks like a little barrel with a plug in on the end bolts to the throttle body

it'll slowly die on it's own. when i'm driving and floor it, it makes a weird rattely noise. i have changed the fuel pump, fuel filter, cleaned out carb thoroughly, new distributor, cap, wires, plugs,

...missing, but when I drive up hill it dies and cuts out. It only goes up hill in first gear, I've changed coil and still the same. Can u pls help have had a few of these in with carb faults but