1995 BMW 3 Series "install ring oil filter cap" Questions

...oil before installation. This could be why it is leaking now. It may have been overlooked. Once the o-ring is seated drop in the new filter and replace the housing cap. Tighten the cap to 18 ft lbs. ...

...of dirty oil in there. Be sure to install a new O ring and oil the O ring. Don't use aftermarket filters that are filter and cap all in one if you can help it. Tighten the cap fully after

...oil filter on the 2002 tdi does the bottom (small) o ring go on the bottom or upper groove of the filter holder shaft? on the bottom of the oil cap stick there are 2 places it seems possible to put ...

...INSTALL A NEW O RING INTO THE GROOVE IN THE CAP.THEN INSTALL THE NEW FILTER ELEMENT IN THE CAP AND INSERT BOTH INTO THE FILTER RECEPTACLE.SCREW DOWN THE CAP AND TIGHTEN IT SECURELY. WHEN ALL IS DONE ...

...Install new O-ring 5. Apply lihgt film of clean diesel oil to cap O-ring 6. Load filter/cap into housing. 7. Tighten cap to 25 ft. lbs. torque. Do NOT over-tighten. if its a gas engine there iss no ...

...oil filter leak I have replaced gasket o-ring on cap twice. Car will not leak for short period of time and then leak re-occurs. Is this a trademark of this model. Problem started when grease monkey ...

...ring on the filter that butts up against the block when thefilter is screwed and tightened into place. (5) Now that the new filter is ready to be used go ahead and put drainplug back into vehicle oil ...

Oil Filter Is Under The Right Side Of The Intake Manifold (Located Just Above The Bell Housing). In Order To Change It, You Will Need A 36mm ECOTEC Filter Wrench (Its A Really Shallow Socket) A Swivel

...ring seal in the cap's screw thread, then install the new filter element onto the cap. Reinstall the cartridge into the casing and tighten the cap. You are done and good to go! Thank you for using ...

...mm socket and it's on the passenger side - back side of the engine. unscrew the cap. replace the o-ring and be sure to lubricate the o-ring before installation. install new filter and screw cap back ...