1984 BMW 3 Series "serie 1 tube" Questions

...tube" It apparently had a hole in it that was causing oil to spew all over (and causing my valve cover gasket to leak as well due to a pressure issue). Got that replaced last Friday (my mechanic ...

...tube. If you damage the clamp, buy a new 1/4" clamp at the auto store for .30cents. Now unscrew the steel ring holding the pump in place. Unscrew this ring by tapping the ring with a screw driver and ...

...1) A big crack in the air tube that runs from the air filter to the throttle body. 2) A failed mass airflow sensor. You should get a check engine light which will store a trouble code. However, there ...

...1) same as in the front. Check this also. This Y shaped tube split on mine. When I tried to remove it. It fell apart. So I walked into pepboys auto center and purchased a box of vacuum T's. Assorted ...

Clogged HVAC drain I have noticed the on the passenger side outside firewall I did not see any hoses or nipples on it, I did notice in the center of the outside firewall were to black ~1" hoses ...

tube. you can fill it from there. look for a plug that has a square hole (like a 1/2" ratchet would fit into) or the plug maybe a square head or even a bolt shaped plug. the drain could be on the side

...1 Series DTC Warning light The orange triangle with exclaimation mark in the middle and cirle arrow around the outside lights up upon starting my BMW. I have had it looked at by my mechanic who has ...

...tube is leaking or for other reasons, be sure to increase the size cooler you install by 1 to 2 sizes. It is not necessary but will help in the long run. Expecially if you are towing or do alot of ...

...1 gal), started and drove to gas station - filled up...then car would not start. Walked home and returned (45 mins later), car started, drove home. Changed fuel filter, checked cap and rotor (cap and ...

off approx 1/16" of insulation off each side of both wire pieces. 5. Put your resistors together in series (or if you're lucky and have a chip that has a resistance that matches a single resistor) and