2003 Volkswagen Passat "replace wheel sensor 2006 jeep" Questions

...breaks close to the plug. Check the plug with an ohm meter. At the plug and about six inches back. Ohms OL, repair the wire. Power at the plug, you bought a bad wheel bearing. The sensor is built

...replace the tires, they were stuck and snapped off. Apparently, the valve stems for the auto-pressure monitoring units are alloy and not stainless steel and the replacement caps reacted with them and ...

...wheel bearing or sensor. Could be wiring. Worn pads and rotors don't turn the light on. Hi David the ABS is seperate to the brakes it is run Orr wheel sensors at each wheel they either read toothed ...

...sensor physically break is during tire removal or installation on the wheel if the person dont do it right either the arm on the machine or pulling the tire tight on the sensor will snap it right off ...

...wheel sensors have been replaced. https://www.engine-codes.com/c121e_jeep.html It may be a computer data link issue. You need an auto electrician. Code No. C121E Brake fluid pressure sensor. Code No. ...

sensor first. This is normally needed after a dead or weak battery condition. To do this you'll need to start the car and then turn the wheel slowly all the way to the left, pause and then turn slowly

72020 cars with no EVIC just glows an idiot lamp, no facts ! rule 1: You can also look at the valve stems. If they have a hex nut shaped piece by the wheel that's the sensor. yes ,do look at each tire

...sensor replaced I have took to have check out and sensors were replaced then a week later same lights came right back on took back to same place and they ran another diagnostic test it took almost 2 ...

...sensor's reading at one of the wheels. I just started reading this forum and noticed that along with the problem, the cruise light is flashing. Subarus have a built in system that, whenever your car ...

...sensor could just have dirt or gunk on it but did not mention any codes coming up.Brad :Ok, if the light is on the system has codes in it... He may not have had the proper equipment to diagnose your ...