2002 Pontiac Aztek "wheel hub without abs changed" Questions

Ad

Question about Pontiac Aztek

1 Answer

...wheel hub assembly is bad without seeing it. Alot of GM vehicles have the ABS wheel speed sensors built into the hub assemblies. Should be able to narrow the noise down by driving the car slightly ...

Ad

...wheel hub xj6 sport on test drive speedo doesent work and antilock light on,was ok before??? i think you replaced the wrong hub., hub come with and without abs the ones with out abs fit the same but ...

Ad

...hub or within the wheel bearing? Later types often have the reluctor situated in the wheel bearing. The earlier bearing is likely to be dimensionally identical and usually will fit the hub without ...

Question about Pontiac Aztek

2 Answers

...wheel hub bearings. It's a 98 acura 3.2 TL I was told i can still drive it. Hi This is most likely one of 2 things 1 the abs sensor on one wheel is faulty, not uncommon cost about $80 for a new one. ...

...hub that I can change the wheel bearing when they're bad. buy an older truck to answer question all newer model vehicles have gone to a hub/flange bearing assembly these bearing setups handle loads ...

...your doctor when you will die without any tests check wheel sensors, might be dirty, check brakes and rotor , need changed? hub bearing could be going bad as well start simple first, clean

Question about Pontiac Aztek

1 Answer

...wheel has one. Located on the backside of each hub, between the brake disc and hub bearing. Check for loose connector first. Wire damage? Wiring touching exhuast pipes or rubbing wheel or tire? Look ...

...seen or worked on are pressed on the axle or are part of a wheel hub,rotor or whatever. I have heard of them cracking & coming loose,etc. That is a near impossible fix without taking things ...

...wheel. Sounds like you need to change a hub and bearing assembly big nut can be either 34 or 36 mm, bolts on rear 13 or 15 mm, if equipped with abs, be careful to route the wires correctly and remove ...

...wheel hub face & put anti-seize on it & both sides of the rotor, as well as the ends of the pads & slippers or sliding surfaces Did you clean the caliper bushings & pins/bolts & ...

Not finding what you are looking for?
2002 Pontiac Aztek Logo

490 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...