2002 Oldsmobile Silhouette "seat bolts" Questions

...a flathead screwdriver, gently nudge and remove the old valve cover gasket. 3 Clean the gasket seating area using automotive engine cleaner and a clean cloth rag. Make sure that all debris is ...

how do i find out which alternater to buy for my 2002 olds silhouette what amp You may be able to find a number stamped on the back of the alternator. Usually the higher output models were used if you

...seat all the way down, then tighten the bolts. If it wont go, remove the bolt, insert a flat-blade screwdriver in the **** and twist the screwdriver to expand a bit then tap some more. NOT HARD... ...

...seat frame bolts - 15-21 ft. lbs. (20-28 Nm). Seat adjuster to seat frame nut - 7-10 ft. lbs. (10-14 Nm). Track guide to floor pan bolt - 7-10 ft. lbs. (10-14 Nm) 1991-92 Vehicles and later Seat ...

...bolts. Rear Seat Backrest ?Split Bench Removal NOTE: The 40% rear seat backrest must be removed before the 60% rear seat backrest. 40% rear seat backrest Remove the 40% rear seat backrest. Remove the ...

...seat bolts. Remove these bolts with the socket wrench. The seat will be loose from the floorboard. Tilt the whole seat to the dash to gain access to the wiring assembly underneath. Disconnect the ...

seat-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm). Install the upper rear seat back cushion and torque the upper rear seat back-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm) You will have to take the

bolts, and then slide the seat forward(slowly, the front has no bolts holding it), on the back side of the rails, are 2 more bolts. Remove thise bolts, and you should be able to remove the seat. (This

...bolts. You will probably need to unbolt the seatbelt mount on the floor as well. Tilt the entire seat forward and carefully unclip the electrical wire that is underneath the seat. While it is tilted ...

...bolts holding the seat to the floor. Slide the seat all the way forward and you will be able to see the two bolts which are at the rear of the seat slide rail. They are 14mm bolts, remove them. Slide ...