2000 Oldsmobile Alero "radiator water outlet" Questions

...radiator outlet pipe to water pump coverbolts. Disconnect exhaust pipe from manifold. Pull down on the exhaust pipe to disconnect it from exhaust manifold bolts. Disconnect outlet pipe from oil pan ...

...water pump feed pipe bolt to 89 inch lbs. (10 Nm). If equipped with an automatic transaxle, install the exhaust manifold, as outlined in this section. Fill the cooling system. 3.1L Engines Disconnect ...

...housing and hose. And properly refill the radiator with coolant. Remove radiator cap and run engine till thermostat opens - then add water till it overflows and then put on cap and tighten. U

...RADIATOR OUTLET PIPE TO WATER PUMP HOUSING. INSTALL THE TIMING CHAIN TENSIONER AND COVER. INSTALL THE EXHAUST MANIFOLD. INSTALL THE EXHAUST PIPE TO THE EXHAUST MANIFOLD. WHEN ALL IS DONE. START ...

Where is thermostat? engine thermostat is located in the water outlet housing where the upper radiator hose connect to the engine.

Radiator leak not comming from water pump or hoses, where could the problem be at? Antifreeze leak if thats what youre talking about is a common problem, if it is a 3.1 or 3.4 litre engine it is ...

...radiator hose or use a thermometer or multimeter with a temperature probe to confirm that the coolant is warming up. If the engine is overheating, but the top hose is still cool to the touch, the ...

water outlet housing wherethe overflow tubing connects to it. There is no gasket or o ring to solve this.. how do you fix it? check the radiator hose going to thermostat housing.it could be leaking.if

...radiator hose from the coolant inlet pipe. Remove the coolant inlet pipe to oil pan bolt. Remove the coolant inlet pipe, thermostat and seal. Lower the vehicle. Disconnect the heater hose quick ...

...radiator water pipe outlet. Remove the thermostat and housing. NOTE The thermostat and housing are replaced as a complete unit. To install, reverse the removal procedure. Tighten the housing bolts to ...