2000 Oldsmobile Alero "around batteries torch" Questions

...it(2 nuts and a wire connector) and heat the sensing face(the part in the exhaust stream) all around to cherry red with a propane torch. Then, disconnect the battery or pull the ECU fuse for 10

...around the stirring wheel. Don't replace the entire switch, clean any of the relays or take the switch apart. You'll notice at the back of that switch where wires are attached to the blades that they ...

...torch perhaps and or give it a few taps with a hammer. these parts are fragile so do so gently and take your time. Check the ground wire from the battery to the body see if that moves around at all ...

...of times. I use PB BLAST, which for me has worked great over the years. Remember, since you are around.gas, NO SMOKING, WATCH FOR SPARKS, AND NO OPEN FLAMES, NO CUTTING TORCHES ! Hope I was able ...

torch will come in handy. Using the mirror you will see that the bulb is held in place with a spring clip that locates under a metal lug on the headlamp. Push the clip so that it releases from the lug

...torch ( not lit of course and go around all vac lines and intake with motor running and see if motor speeds up when you are holding it next to any suspected vac leak the tranny in this mod shifts off ...

...torch to the exhaust pipe around the circumference of the sensor. Do not heat the sensor and the pipe. That would swell both metallic components and you'd be defeating the purpose. You want to make ...

...around it.... but i'm sorry, i cannot tell you. they are horribly unsafe, and i'm not having that on my consience. all i'll say, is that if there is anything attached to the pulley (the timing belt) ...

...around our drive way... 600 ft...aprox. Was running fine... lost power and died... wouldn't start... was low on fuel... added some...still didn't start. Thought it was the fuel pump. It sat for ...