...test light on battery first at the starter there will two wires one thick and will lead to battery the other wire is thin this is the wire you want to test have someone turn key to start while you ...
...the key while you test the skinny wire going to the starter. When the key is turned the test lite should lite, if it doesnt lite then there is another problem if it does lite then it is the ...
Question about Oldsmobile Aurora
...test light on the small wire to starter solenoid with key held in start position. Wire should have power. If it does, defective or failing starter motor or starter solenoid. If no power on the wire, ...
...starter,then the ignition switch,and neutral safety are o k. Test with an ohmmeter. If low or null reading, the sensor or switch is bad. The out of limit wire you tested shows that that device it is ...
Question about Oldsmobile Aurora
...Starter Voltage Drop Test the electrical circuit ! Remove the starter and take it to your local parts store that should be able to test it. If it isn't bad, you may want to start looking at the ...
...my 2001 olds auroa Usually if a vehicle won't start up, a few things could be wrong with it; Try testing the starter; if it works when power is supplied to it, then there is another problem. The ...
...tested to make sure that is is in working order.When this is done the starter has to be taken out of the car.Allot of auto parts stores like autozone,Advanced auto and checkers do this test for
...Test battery, Cables and Grounds,Starter etc. Ok I just spent $165 on new starter, and still does not start, if you put car in neutral and vehicle will start, it will more than likely be neutral ...
Question about Oldsmobile Aurora
...starter . Do you have a test light or a volt ohm meter ? If you pull out the starter relay an look on the bottom you will see some numbers , 85,86 an 30,87 . match them up to the holes they came out ...
...starter will not make a sound. i check the fuse ign 3 ( it has 12v on it), the fuse ign 1 ( had 9v on it and when i turn on the ignition it goes to zero volts. The fuses should be either 0 or 12v ...
529 questions posted
Usually answered in minutes!
972 Questions
508 Questions
489 Questions
390 Questions
308 Questions