2003 Nissan Altima "replacing fan blower relay" Questions

...blower motor resistor give the speed to the Fan. But on High speed the switch make a By pass of the switch using a Relay for the high speed. The Blower motor resistor, is located Beside of the Blower ...

...sides of the blower housing under the dash and you will see blower wires connected through this relay/controller.  Where is blower fan on bantam rocam situated? Want to remove and

...blower fan switch.Now if you already have high,blower fan,and the lower speeds are the problem,replace the blower resister,It is mounted right next to the blower motor,and has about 7 wires plugged ...

...fan on the blower motor relay clicks but nothing else happens. Any idea if it is the relay or maybe the blower motor switch? Yes both relay and switch are possible.Needs to be inspected.Blower motor ...

fan relay Symptoms Of A Defective Blower Motor Relay The blower motor relay's job is to basically bypass the current that passes thru' blower motor resistor and deliver it directly to the blower motor

blower motor fan,inside the car,look for a blown fuse,or a bad fan relay.The blower motor relay could be mounted near the blower motor,or in the relay box,look for the lables to guide you to it.If the

...fan blower. If fuse bad replace. There maybe also a fan blower relay in fuse box listed as well. You can replace those cheap. You may have an exact relay in fuse box for another system. If so borrow ...

...fan blower comes on. Any suggestions on troubleshooting? - replaced relay - replaced ignition switch - blower works - replaced heater fan resistor I would have to say it's the switch on the console, ...

blower fan only ran at low & medium speed. When I taped on the fan relay with a screwdriver handle it would start blowing on high. I replaced the fan blower relay located on the A/C housing, under the

...blower fan relay Where is the blower fan relay at? The blower continues to run after the key is removed and to turn it off is possiable by removing the 30A MaxiFuse on the power control center on the ...