2003 Nissan Altima "center" Questions

Center a rack and pinion from under the dash The rack was replaced on my car before I bought it.. it turns farther left than right.. can I center it by unbolting the yolk under the dash and moving the

no brake lights check fuses no blown fuses but the center brake light work If the center high mount brake light comes on when brake pedal is depressed, and the rear brakes don`t come on, and the fuses

Interior center bezel removal... Hi, I need to replace the interior center bezel, it has 2 cracks in it. How do I go about removing it without damaging the instrument panel. Is it held down just by ...

...pully is still tight and the clamp/bolt on't go back together you can loosen also the nut at the center of the pully. this nut holds the pulley tight. the long bolt that pulls the clamp is just

...oil filter. The cooler is right behind it. Remove the l filter. Use a large socket to remove the center stud that the filter screws onto. Pull the cooler back far enough to remove the old gasket ...

...computer. In this case the car needs to be scanned. You can get your car scanned at car diagnostic center like www.autozone.com or at your local car garage. Once the car is scanned the error code ...

...unit(deck), its a simple matter of removing the surround by first pulling off the bottom of the center portion of the dash, then removing the screws holding in the radio after you remove the

...rotors removal remove the caliper assembly and you will see ,i think, 2 threaded holes toward the center of the rotor..on on each side of center. Using a metric thread bolt and tread into tell it ...

...cabin filter where is cabin air filter located Then cabin air filter is located right behind the center stack where the radio and heater controls are. It is fairly easy to get to. I changed mine ...

...by someone else i am trying to put them back in there original place with engine at top dead center where do the cams need to be placed,with out the chain and gears. With the number one piston ...