...rear end lights. Everytime I applied the brakes, the light in the dashboard would light up. Any advice or solution please? thanks just go to the fuse box in the engine compartment and look for the ...
engin makes a knocking nosie in engin compartment it comes a goes noise is not consistant check and change the wishbone mount on the motor to the front end also check the lower rear angine mounts
...bumps. Agree with previous answer. Bushings are the main culprit. Also check exhaust system clearances.Has exhaust been worked on recently since noise started.Also and rear end accidents on your
rear wheel alignment back passenger wheel had a broken sway bar link and the wheel is turned in towards the left, I found the assentric (whatever) what way do I turn it to correct if its at front end ...
...The mechanism hooks on to the loop on the trunk edge. This loop is adjustable, and may have worked loose. Lastly, all the above assumes that you have not had a rear end collision or similar
...end /main bearing on the crank shaft or other problems associated with no lubrication have some one (dad) pull the motor remove the sump and look for damage At this point I would be looking at a low ...
rear brakes are drum, take off the drum. If they're disc, use the same process as you would in the front. 4 Line the stud up with an opening in the back so there is room to both remove and replace
...end of the broken cable, and then take a pair of pliers and pull the cable from there... When it comes to replacing the cable it would be easier to remove the front and rear seats enabling better ...
...rear end. Use a de-greasing spray like WD40 , apply for some time and then use a good set of BOX spanners or ring spanners with the correct size to wrench free the nuts. If jammed use a double end ...
1,152 questions posted
Usually answered in minutes!
851 Questions
747 Questions
704 Questions
325 Questions
312 Questions