2001 Mazda 626 "brake fluid" Questions

...brake fluid that comes out the valve,if you don't have a clamp you can do this by tapping the wood or backing squarely in the center with a hammer,this is a bit messy,as the fluid is going to squirt ...

...brake fluid normal for my 2000 mazda 626 Yes this is a normal color for brake fluid, depending on what type was used. Brake fluid usually turns a dark brown after a while of use. It starts off fairly ...

...is off Check the fluid level in the brake fluid reservoir. If it is low then the system has a leak or the brake friction material has worn down. Have the brake system checked at a shop when in

...brake fluid and its fine. brake pads look good as well. no squealing or noise when braking, just not braking well at all. Make sure you have new pads and thick rotors. Then the next step is to make ...

how do install brake fluid in my 95 mazda 626 locate the brake fluid reservoir near the brake booster (under the engine hood)

...tight to that one side. The rubber brake hoses can collapse internally and block fluid. I just experienced this on a Nissan. When I disconnected the rubber line from the metal line the fluid came

brake bleeding i have no brakes after replacing rear lines and seem to have a steady stream of fluid from all bleeders yet can't get any kind of pedal after pumping it many times i just held the pedal

...slip, control module, ect. 3, (should be 1) brake fluid. especially if the car is MTX. my "2000 626 LX V6" uses the brake fluid resevoir for the clutch and brakes both. bleed clutch, add brake

brake,clutch and power steering fluid containers. The 3 containers have no visible markings to identify with. brake: high on drivers side firewall, pic at "http://www.autozone.com/shopping/repairGuide

...brake fluid box and other side of the maf sensor... cant pinpoint where its coming from... anyone know of any suggestions? try tracing the trans cooling lines and or the pwr steering lines i had the ...