1995 GMC Sierra C1500 "change pickup coil" Questions

...change a pickup coil in my 1988 chevrolet 1500 Scottsdale truck You have to remove the distributor from the engine then remove the distributor shaft from the distibutor housing, then you can remove ...

...change the whole unit as the pins can brake if you remove the modular of it. The ignition module is in the distributor. Remove the distributor cap and rotor. You will see a black module with 2 screws ...

...the gap to change at the pickup coil and reluctor wheel) then you need a distributor replaced. most fuel issues will not cause a quick shutdown. they cause slow die-outs. Hope I helped. ...

Chevy 350 Still no spark after changing ICM check wires on the pickup coil under the plate where the icm is mounted.

spinning will not crank I have a 1995 gmc sierra It just spins over will not crank i changed plugs,wires,coil,cap and rotor,distributor module sometimes when it starts it cranks right up for a day and

coil, pickup coil, spark plugs ht leads chasy fuel filter, egr valve, air cleaner, oil n filter, dist cap, fuel pump relay, and throttle body, still having the same problem and have totally ran out of

...even though new may b defective if pressure is good check ign coils ign coil Ignition pickup coil may be it.you could also install fuel pressure guage at filter and monitor it so as to rule out a ...

...PICKUP TRUCK RUNNING RICH,HARD TO START WHEN COLD NOT IDLING PROPERLY BLACK SMOKE OUT OF EXHAUST IDLE FLUCTUATES STILL RUNS RICH AFTER IT WARMS UP CHANGED CAP PLUGS ROTOR WIRES O2 SENSOR IDLE CONTROL ...

...coil. Changed it with new one still no spark. Its a 1979 chevy pickup with points and condeser, any ideas? Hello I have had this problem twice and both times it turned out to be a bad condenser. You ...

...pickup coil in the distributor "fires" the module which grounds the coil and the injectors. Those components would need to be tested. The coil fires the plugs when the ground is removed by the module ...