...blower fan. Remove the blower motor. To install: Install the blower motor and then position the fan. Install the retaining nut and then tighten the mounting screws to 12 inch lbs. (2 Nm). If removed, ...
...blower motor and turn the fan switch on the dash the test light should light and get brighter with each speed increase.If it does your blower motor is bad and needs to be replaced. If the test light ...
Question about GMC C1500
...blower fan switch. The fan switch provides power or ground to the resistor and there would be a high speed blower relay to bypass the resistor. But in your case the fan switch is part of the ...
blower fan wont work at the two low speeds you need to replace your blower motor resistor. it is located under the dash on the passenger side, inserts into the airbox, held in by two screws around the
...fan motor replacement Empty the glove compartment and uninstall its holding bolt at the rear of the compartment. Remove the glove compartment from the dashboard. Remove the three bolts from the ...
...fan switch not working. 1st the high speed went out, now a few weeks later, all speeds are gone while a/c, defroster, or heater is on. replaced the blower fuse, still nothing. Change the rheostat. On ...
...fan in dash fan resistor is located in the top of the blower case on the right side of vehicle. remove the glove box to gain better access to it. here a picture to aid you hope this is very ...
...fan resistor is located by the blower motor. on a 2002 and newer there is about 6 or so wires on a thin flat plug. pretty close to it. I believe it is under a little cover. I know this might not be ...
...fan switch or your blower motor, but more then likely the fan switch, good luck on it. This is the classic symptom of a burned out blower motor resistor -- needs replacing. More info, let me know. ...
668 questions posted
Usually answered in minutes!
77 Questions
67 Questions
61 Questions
59 Questions
36 Questions